General-tools-and-instruments PM930SD Manuel d'utilisateur

PM930SDUSER’S MANUAL LIQUID OR AIRPRESSURE METER WITH DATALOGGING SD CARDPlease read this manual carefully and thoroughly before using this product.

SPECIFICATIONS Embedded microcontroller Custom one-chip LSI deviceDisplay type Liquid-crystal with green backlightDisplay size 2.05 x 1.5 in. (52 x 3

OPTIONAL ACCESSORIES • Pressure sensors with the following full-scale ranges: 2, 5, 10, 20, 50, 100, 200 and 400 bar• 9-VDC adapter for 110VAC power s

GENERAL TOOLS & INSTRUMENTS80 White StreetNew York, NY 10013-3567PHONE (212) 431-6100FAX (212) 431-6499TOLL FREE (800) 697-8665e-mail: sales@gener

TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3Key Features . . . . . . . . . . . . . . . . . . .

INTRODUCTION Thank you for purchasing General Tools & Instruments’ PM930SD Liquid or Air PressureMeter with Datalogging SD Card. Please read this

OPERATING INSTRUCTIONS WHAT’S IN THE CASEThe PM930SD comes fully assembled in a carrying case along a 2 GB SD memory cardwith this user’s manual. Opti

SETUP1. Choose the power source. Before using the PM930SD, be sure it is powered by freshbatteries or an optional 9VDC AC adapter plugged into the bot

Pressing the REC/ENTER button causes the word “no” or “yES” to appear over the term“Sd-F”. Press the SET ▼ button to make a selection. Choose “yES” wh

7. Choose the full-scale range of the optional pressure sensor. Once the format ofdecimal divisions has been set and stored, the term “tyPE” will appe

HOLDING AND STORING MEASUREMENTS1. To hold a measured value of pressure, press the HOLD/ESC button during themeasurement. Doing so will cause the word

5. To change the storage location of manually logged data, press the ▼ button once;this causes the “P” to disappear from the left side of the display