General-tools-and-instruments HT10 Manuel d'utilisateur télécharger pdf (Page 13)

OPERATING INSTRUCTIONS

DEPLOY THE UNIT

The HT10 is particularly easy to deploy on a job site because

the unit does not need to be plugged into a computer to be

activated (ready to start logging data). Working together, the

MODE button and the pair of two-color LEDs (Fig. 1, Callouts

F and C) serve as the control and indicators needed to: 1)

start and stop data logging and 2) verify and change the unit’s

working status.

That leaves only two things to be sure of when choosing a

place to deploy the HT10:

• The temperature and humidity sensor window

(Fig. 1, Callout A) is not covered

• The humidity and temperature values at the unit’s

location are “representative” of the room

The HT10—with its protective cap on—can be deployed

either by laying it on a horizontal surface or by hanging it

vertically within the included plastic mounting bracket. The

back of the bracket features both a magnet and a hanger

hole.

Once you have deployed the HT10, you can initiate data

logging. To start data logging, press and hold the MODE

button for at least 3 seconds. Both LEDs will flash green

twice to confirm that logging has begun.

STOP LOGGING AND IMPORT LOGS

To stop data logging, press and hold the MODE button for at

least 3 seconds. Both LEDs will flash red 2 or 3 times to

confirm that logging has stopped.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

General-tools-and-instruments HT10 Manuel d'utilisateur Page 13